
? The “PWR and the board is not in hibernate state. when power is
Getting Started
Powering Up/Down the ICE-100B Emulator
To power up the ICE-100B emulator:
1. Apply power to the target board.
2. Connect the USB port on the computer to the ICE-100B emula-
tor. ?
?
The ICE-100B is a bus-powered device, so this step powers the
emulator.
3. Connect the ICE-100B emulator JTAG connector to the target
JTAG header.
4. Invoke VisualDSP++.
To power down the ICE-100B emulator:
1. Shut down (exit) VisualDSP++.
2. Disconnect the USB cable between the ICE-100B emulator and
the PC.
3. Power down the target board.
” LED (power LED) should be green
applied
4. The ICE-100B emulator can now be removed from the target.
For custom processor boards still in design, refer to Engineer-to-Engineer
Note, Analog Devices JTAG Emulation Technical Reference (EE-68) ,
available from the Analog Devices Web site. This document is a technical
reference for implementing the JTAG interface on your target.
The emulator hardware is ready to be used in conjunction with
VisualDSP++ to debug a processor target system.
ICE-100B Emulator User Guide
1-7 ?